IMPORTANT: Smoke detectors must be tested and maintained regularly following NFPA.
The 300301 must be enrolled into the CP-3000 Fire Alarm Control Panel before installing.
Select an accessible location that is not prone to tampering or accidental damage.
The.
Model 300301 must be installed and maintained in accordance with the National Fire.
Protection Associations Standards (NFPA), the National Electrical Code and all local.
Attach he detector to the bracket by turning the detector in a clockwise direction until it.
The smoke detector includes a tamper-resistant feature that prevents removal from the.
In or near areas where particles of combustion are normally present such as.
In wet or excessively humid areas, or next to bathrooms with showers.
Drivers education final exam answersNear fresh air inlets or returns or excessively drafty areas.
The 300301 detectors are equipped with two LEDs status indicators and a sounder to.
When the detector senses smoke the Green LED extinguishes, the Red LED turns on.
The model 301 has a feature which allows the smoke detectors piezo sounder to be turned.
Panel to function.
Refer to the CP-3000 manual for additional information and programming.
A tandem silence signal will be required to turn off the sounder.
Detectors must be tested after installation and following maintenance or battery.
Drivers pcchips m756lmr para xpPerform both A and B below to properly test the 300301 detector.
Note: This test will only function if the detector is operating within its proper sensitivity limits.
The purpose of this test is to check the functionality of the circuitry.
Note: This test will cause an alarm signal to be transmitted.
The test must be performed while the smoke detector is held in its intended mounting.